We do not exchange your motor for another part! Corvette Specialties of MD West the restoration leader! Rebuild and cosmetics including new main drive gear. The repair kit contains Delrin bushings that replace the gel and allow the motors to operate properly.
Easy installation - one kit needed per motor.
Instructions included. In this video I go into some details that I feel were missed in some of the other videos and I really think they help to make the process a. Spray some WD-on the heads to help loosen them. On the motor gear shaft that passes through the headlight linkage you will see a very small retaining ring on the very end of the shaft.
FREE Shipping by Amazon. The headlight motor rebuild , could send them off for $1per motor , or do it myself. We started out by checking on the condition of the electric motor.
Looking For Great Deals? Check Out Top Brands On eBay. We Have Almost Everything On eBay. This rebuild service is offered for the owner who wants to retain the original motor that was installed in the Corvette.
See alternate parts shown below. The defective headlight door motor is removed. The new headlight motor is installed. The hood manual support is removed. The repair is verified and the headlight door motor is tested for proper operation.
And even in a worst-case scenario-that of a failed actuator-it should only take around two hours to rectify the. If your headlight isn’t already in the fully up position, you’ll need to get it there manually before removing the assembly. Remove this rubber cap and turn the knob on the back of the headlight motor counter-clockwise until the headlight reaches its apex. It may take quite a bit of turning before the headlight begins to rise.
The parts and labor required for this service are. Detach the headlight motor wire on the outer side of the headlight. Turn the headlights off (the disconnected light should stay open).
Unfasten the screws at the bezel. There are at the front and at the sides. This is a completely drilless installation. With complete plug and plug harness.
All you need is a standard relay and some wire. If you are doing the auto-rollover, you need to drill the second mounting pad to accept the switch. Fill Your Cart With Color Today!
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.