Pocket door repair

How to repair and replace a pocket door? How do you fix a pocket door? Pull out a door that’s stuck in the pocket by alternately pulling the top and bottom edges. Remove a door from a J-track by following the instructions in Photo but instead of pulling the top toward you, push away to pop the rollers out of the track. Remove a door with roller-skate-type rollers by prying the door up and tapping on the rollers to release them.

Other articles from familyhandyman.

If the pocket door is off of its track, you’ll have to remove it before you can repair it. To do this: Use a utility knife to break the paint seal along the stop moldings on each door jamb, and then carefully pry off the moldings with a chisel or a 5-in-tool and flat bar. I hope this video empowers the handyman inside you to tackle the next DIY project on your list!

From a generic standpoint, the major problems faced by pocket door owners involve the adjustment of the rollers, their attachment to the door , lubrication and defects or looseness in the track. I suppose toys jammed into the pocket can be added to this list, too! This procedure includes guidance on repairing balkiness or binding of apocket door. This includes work on a door that may be stuck in its pocket, thatbinds when being move or that resists movement or is balky when being moved.

It may also be applied to pocket doors that will not slide completely into thepocket.

Emphasis is placed on how to replace moldings in such a way that. To replace your ​pocket door , you will need to cut a hole in the wall for access to the rollers and track system in addition to removing the frame of the door. You will now have complete access to the roller and track. You can remove the old door by tilting it downward and removing it from the rollers. With a pocket door you want to attach the hanger that is closest to the pocket side of the door.

Slide the pocket side hanger to where it is about six to eight inches from the edge of the jamb. Before we jump to the conclusion that ​you need to cut ​holes into the wall, it is always a good idea to lubricate the. You may also want to inspect the screws that were used to hold your ​sliding door in place. Many times, these screws do. Sometimes even metal stud drywall screws are used.

This is a common task when you are installing new flooring that is thicker than the old flooring. You need to remove the pocket door and trim to accommodate the new floor. It’s easier than you think. Replacing the track can be a big job that may even require some drywall patching. Most of the time it is just some adjusting and lubricating.

A few minutes work and your door will be quiet and smooth. Replace old tracks with a heavy duty commercial track and roller system without any wall damage. Pocket Door Repair Co.

From design to finish We custom fit and finish pocket doors and track systems to ensure a smooth and reliable door. Find out more about the pros and cons of including a pocket door in your project. Shop pocket door hardware and a variety of hardware products online at Lowes.