Repair touch lamp

How to wire a touch lamp? Installation mostly involves nothing more complicated than following the color-coded wiring. Resetting the touch lamp requires replacing the touch-control box.

Remove the finial holding the shade onto your touch lamp. Take off the lampshade to access the lamp harp. Squeeze the sides of the.

Check that all the wire connections are inside the lamp. If necessary, cut and rewire with wire nuts. Replace the touch sensor located at the base of the lamp. You can use an orange wire nut to twist the wires together so that they will fit more neatly into the box. Put a light bulb in the lamp and plug it back in.

Finally, touch the lamp to turn it on and be sure it is working. If you are confident with soldering and general electrical work, this CAN be fixe provided the electronic unit that contains this part is not sealed with a potting compound. Touch lamp replacement part.

This is what you need to buy to repair a touch lamp. Find Great Deals Now! Unplug before attempting anything on any lamp. Buy Top Products On eBay. Money Back Guarantee!

Although a simple fix the electronics are pretty complicated. To make the repair , you will need to purchase a new control. This control is located under the base where the felt or rubber base is located. The cost of lamp repair is between $to $10 depending on the complexity of the problem. Picture of what makes a touch lamp work.

Prices to repair a lamp vary widely, due to the many styles and ages of lamps. Explore other popular Home Services near you from over million businesses with over 1million reviews and opinions from Yelpers. Includes pre-stripped leads, wire nuts, and trilingual installation instructions. Works in any touch lamp. Set your store to see local.

Shop Lamp Parts online at AceHardware. Free Store Pickup at your neighborhood Ace.

The lamp can be salvaged by replacing the original touch dimmer control with a universal replacement dimmer control. A touch lamp must not be plugged into a wall outlet that is controlled by a wall dimmer, simply move lamp to another. Pull the socket switch up out of the shell base to expose enough of the switch to reveal the two wires attached to it. If the screws are loose, tighten them and reassemble the lamp.

Loose screws may have been the lamp’s only problem. If the lamp works after you tighten up the screws, great! Feed the cord up through the threaded tube in the lamp’s body (Photo 2).

Then connect the new cord to the socket. Most cords come with the ends already strippe so you won’t even need a wire stripper for this how to rewire a lamp project. Add a new lamp base socket and cover if yours is cracked or if you want to use a different bulb type. We have also sorts of lamp switches, including flip switches, pull chains and touch switches.

Want to link your lamp to a computer or smart TV? Just get a video connector or HDMI coupler - when you turn your device on, the light will come on, too! Add a measure of safety, security and convenience to everyday life with Westek timers, light controls and dimmers.