Ps3 controller repair

How do I unsync a PScontroller? How to resync a PScontroller? Where is the reset button on a PS3? Repair and support for the controllers that shipped with the PS3. If the analog stick popped out of place, you can repair it by taking the PScontroller apart and reattaching the piece.

Many companies offer replacement analog sticks for less than $10.

PlayStation Repair. Remove the two screws holding the motherboard to the front controller housing. Next, remove the motherboard assembly from the controller housing. This is done by pressing in the clips on each side of the handle. Freeing the motherboard from the housing will provide better access to the charging port.

Please comment if you have any questions. Reset the Wireless Controller If you are experiencing difficulties with the SIXAXIS or DUALSHOCK wireless controller for the PS, you may want to reset the controller to default settings: Locate the small reset button on the bottom of the SIXAXIS or DUALSHOCK wireless controller near the Lshoulder button. Verify if the SIXAXIS or DUALSHOCK wireless controller works with the USB cable.

Try resetting the PSby turning it off and then back on. Attempt to PS: Pair and Assign Controllers (SIXAXIS or DUALSHOCK 3) wireless controller to another PSsystem. This helps determine whether the problem is with the system or the controller.

Now before we can pull it apart we have to unclip the clip on the front of the controller between the two analog sticks. PSController Disassembly Now detach the battery by pulling it straight. To remove the defective charging port, you will need to de-solder the pins holding the port to the motherboard.

First, used the desoldering pump to remove the solder from all pins. Then, use the desoldering wick to remove any excess solder left on the motherboard. Only non-conducting lubricants should be used on the controller. Remove all five screws on the back of the PScontroller.

Remove the back of the casing from the controller , exposing the interior. The battery is the plate on top of the circuit board. You have to dismantle the white plastic insert inside the controller to be able to clean the front buttons. To do it: push on the little brackets around the rumble motors in the handles.

Use a cotton swab and alcool. The first step to fixing anything is to take it apart and understand its components. Taking apart the controller is as simple as removing a few screws.

See the Screwdriver row in the table below to find the screwdriver needed.

The rest button will override all the settings on the device and set it to factory defaults. To reset the PScontroller , Place a safety pin inside the small hole which is present at the left side of the right screw on the back of the controller and press it for few.